Figure 5. How a Profit-Maximizing Monopoly Decides Price In Step step step one, the monopoly chooses the profit-maximizing level of output Q1, by choosing the quantity where MR = MC. In Step dos, the monopoly decides how much to charge for output level 1 by drawing a line straight up from Q1 to point R on its perceived demand curve. Thus, the monopoly will charge a price (P1). In Step 3, the monopoly identifies its profit. Total revenue will be Q1 multiplied by P1. Total cost will be Q1 multiplied by the average cost of producing Q1, which is shown by point S on the average cost curve to be P2. Profits will be the total revenue rectangle minus the total cost rectangle, shown by the shaded zone in the figure.
From the discounted with the all of the tools sold, the brand new marginal funds out-of attempting to sell a product is actually lower than the fresh cost of you to equipment-while the marginal cash curve are underneath the consult chat zozo ekЕџi bend
The marginal revenue curve for a monopolist always lies beneath the market demand curve. To understand why, think about increasing the quantity along the demand curve by one unit, so that you take one step down the demand curve to a slightly higher quantity but a slightly lower price. A demand curve is not sequential: It is not that first we sell Q1 at a higher price, and then we sell Q2 at a lower price. Rather, a demand curve is conditional: If we charge the higher price, we would sell Q1. If, instead, we charge a lower price (on all the units that we sell), we would sell Q2. Continue lendo “Why is an excellent monopolist’s marginal revenue usually below the price?”